Fitment:

• 1995-1996 Buick Century
• 1996-1998 Buick LeSabre
• 1996-1998 Buick Park Avenue
• 1996-1998 Buick Regal
• 1996-1998 Buick Riviera
• 1996-1998 Chevrolet Camaro
• 1998 Chevrolet Lumina
• 1998 Chevrolet Monte Carlo
• 1996-1998 Oldsmobile 88
• 1996 Oldsmobile 98
• 1996 Oldsmobile Cutlass Ciera
• 1998 Oldsmobile Intrigue
• 1996-1998 Oldsmobile LSS
• 1997-1998 Oldsmobile Regency
• 1996-1998 Pontiac Bonneville
• 1997-1998 Pontiac Firebird
• 1997-1998 Pontiac Grand Prix 

Features:

• 100% Brand New Mass Air Flow Sensor
• Directly Plug-in Replacement
• Made of Supreme Quality materials
• Easy to install
• One year warranty and worry-free service and technical support. 

Know the MAF Sensor:

• A mass airflow sensor, or MAF for short, is found almost exclusively on fuel injected engines. A MAF is an electronic device that runs between your vehicle’s airbox and intake manifold. It measures the amount of air that passes through it, and sends this information to the engine’s computer, or ECU. The ECU takes this information and combines it with air intake temperature data to help determine the proper amount of fuel necessary for an optimal combustion. If your vehicle’s MAF sensor is failing, you will notice rough idling and the vehicle running rich.
• When a MAF sensor is used in conjunction with an oxygen sensor, the engine's air/fuel ratio can be controlled very accurately. The MAF sensor provides the open-loop controller predicted air flow information (the measured air flow) to the ECU, and the oxygen sensor provides closed-loop feedback in order to make minor corrections to the predicted air mass. 

Symptoms the MAF Sensor Needs Replacing:

• Check engine light is on
• Car lazy on acceleration
• Rough engine
• Increased fuel consumption
• Car runs better when the MAF sensor is disconnected
• Lack of engine power
• Engine surge at idle
• Data diagnostic points to MAF sensor
• Sensor fails to respond to signal

Know how to Replace the MAF Sensor:

• Step 1: Disconnect the electrical connector from the mass air flow sensor.Squeeze the tab on the harness side of the electrical connector while firmly pulling on the connector.
• Step 2: Disconnect the mass air flow sensor. Use a screwdriver to loosen the clamp or screws on each side of the MAF that secure it to the intake pipe and air filter. Once the clamps are removed, you should be able to pull the MAF right out.
• Step 3: Connect the new mass airflow sensor.The sensor slides into the intake and then is clamped on.
• Step 4: Reconnect the electrical connector.Reconnect the electrical connector to the new mass airflow sensor by sliding the female side of the connector over the male side that is attached to the sensor. Press firmly until you hear a click that indicates the connector is seated all the way and locked into position.